Welcome to BigScreenBiz.com

I have bought a lot of projection equipment on ebay and fortunately have never been burned. Recently, because of my new theatre, I have been in an ebay frenzy and have nearly completed revamping the entire booth.

I bought a Dolby CP200 with the following cards in the control unit: Cats: 156-2, 157-2, (3) 153, (2) 154, (2) 117-3, 137, & (3) 64B
The processor unit contains: Cats: 108C, 201, 143-1, (3) 141A, (4) 22, (3) 109C, (2) 207, 160, 150D, & 142.

I also bought (2) 517 cards, a 137L, and a 560 sub card.

Is there anything else I need in the processor to run dts?

You will also need a breakout board from DTS if you use the DTS 6D it will have a set of dip relays to break the JM11/Jm21 connection on the processor
The DTS 6 you just need the ribbon cable with the 50 pin DSub on one end
I usually route the DTS sub into the CP200 at the same point as a DA20 and build format 10 as the digital format

It is a dts 6D that I will be using.